Code center > Suggestions

Things that piss me off in 2.4.9.

<< < (3/4) > >>

Testlund:
I really wish I could change brownian motion. I really do. I think 10 is too much, but it's going to be set at 10 wether I like it or not. Breownian movement is going to stay set at Animal. If it isn't like that for you, Nums, then there isn't anything you can do about it, I guess. A dead end.

Testlund:
I guess you were right that day/night cycles works.  :redface:

But it doesn't display right. With day/nicht cycles set to 10000 I found that it starts with night, displaying the sun icon (!)  :huh: , but the veggies are sleeping. Then after 10000 cycles it changes to day, still displaying the sun icon, and the veggies wakes up. Then when it reaches 20000 cycles the veggies goes to sleep again, but THIS time the moon icon shows! How was I supposed to know??

Numsgil:

--- Quote ---I guess you were right that day/night cycles works.  :redface:

But it doesn't display right. With day/nicht cycles set to 10000 I found that it starts with night, displaying the sun icon (!)  :huh: , but the veggies are sleeping. Then after 10000 cycles it changes to day, still displaying the sun icon, and the veggies wakes up. Then when it reaches 20000 cycles the veggies goes to sleep again, but THIS time the moon icon shows! How was I supposed to know??
--- End quote ---
You weren't, it's a bug, thanks for reporting it.

Numsgil:

--- Quote ---I really wish I could change brownian motion. I really do. I think 10 is too much, but it's going to be set at 10 wether I like it or not. Breownian movement is going to stay set at Animal. If it isn't like that for you, Nums, then there isn't anything you can do about it, I guess. A dead end.
--- End quote ---
Have you tried going into the advanced physics panel?

Testlund:
YES!

To be specific:

On the 'Physics and Costs' tab you can change brownian movement between animal and bacteria. If I change to bacteria it will go back to Animal as soon as I click on another tab or after I've been in the 'Advanced Controls' section. On the 'Advanced controls' section (you say advanced physics but I assume you mean advanced controls. Can't find anything called advanced physics), if I change the slider for 'Brownian motion', click ok and then click on 'Advanced Controls' again the 'Brownian Motion' is back at 10. I can't keep it set to a lower value than 10!

Navigation

[0] Message Index

[#] Next page

[*] Previous page