Darwinbots Forum

Code center => Bugs and fixes => Topic started by: Botsareus on May 10, 2012, 03:08:35 PM

Title: Cost multiplier is zero
Post by: Botsareus on May 10, 2012, 03:08:35 PM

Every time I continue last simulation cost multiplier is reset to zero.

However, Sometimes it works when you try to load settings first.

---

One more thing, If I go into settings and try to change it, it says "Internet paths must be a valid directory" but I am not running internet mode...

Title: Re: Cost multiplier is zero
Post by: Botsareus on May 10, 2012, 04:30:36 PM

update: I think it resets to zero when UpdateSim() is called

Title: Re: Cost multiplier is zero
Post by: Botsareus on May 10, 2012, 04:46:37 PM

lol, found it:

Apparently cost multiplier is set to zero if I run a veg only simulation.

Title: Re: Cost multiplier is zero
Post by: Botsareus on May 10, 2012, 04:57:04 PM

I found this out the hard way:

a fear warning to all:

If you are running a veg only sim, set this to -1 :