Darwinbots Forum

Code center => Suggestions => Topic started by: EricL on March 25, 2008, 10:42:49 AM

Title: 10 in/out sysvars in 2.43.1e
Post by: EricL on March 25, 2008, 10:42:49 AM

Can't find the thread where this was requested, but 2.43.1e increases the number of .in and .out sysvars to ten each.

Title: 10 in/out sysvars in 2.43.1e
Post by: Numsgil on March 25, 2008, 02:12:12 PM

Title: 10 in/out sysvars in 2.43.1e
Post by: rsucoop on April 06, 2008, 02:05:31 PM

Is there a cycle system for refvals? making it so a bot can read from any given eye at once?

Title: 10 in/out sysvars in 2.43.1e
Post by: Numsgil on April 06, 2008, 03:57:50 PM

Do you mean .focuseye, or do you mean reading from different eyes in the same cycle?

Title: 10 in/out sysvars in 2.43.1e
Post by: rsucoop on April 06, 2008, 04:04:17 PM

reading from different eyes in the same cycle.

Title: 10 in/out sysvars in 2.43.1e
Post by: Numsgil on April 06, 2008, 04:06:07 PM

Then no, there isn't a way to do that presently.  It's not technically impossible, but it would mean either some command to switch the focus eye, or having sysvars for every eye.  Either way, I'm not a fan of the idea.  I rather like that it takes a full cycle for a bot to look at something it saw in an off eye.