Darwinbots Forum

Code center => Bugs and fixes => Bug reports => Topic started by: Testlund on September 16, 2014, 08:35:58 PM

Title: Run-time error 9
Post by: Testlund on September 16, 2014, 08:35:58 PM
I just got this when I was running 4 instances with one in IM. DB didn't have time to autosave so I'm posting what I got. No Safe Mode option for this one.
Title: Re: Run-time error 9
Post by: Botsareus on September 16, 2014, 08:47:46 PM
At this point if no one can get it to crash at startup in the 2K cycle window, have fun  :(
Title: Re: Run-time error 9
Post by: Botsareus on September 16, 2014, 08:54:45 PM
Here are the steps:

swap the global.get file with one attached.

go to setting and load the attached settings (.set) file, start a new sim

exit the program

open the program again, do not select continue last simulation

go to load simulation and load the simulation (.sim) file attached
Title: Re: Run-time error 9
Post by: Testlund on September 17, 2014, 06:53:00 AM
OK, forget about it for now.

This only happens in IM. I crashed with this sim 3 times last night. I'll run it again tonight and see if I can get an autosave too. If you load that autosave and connect to IM you should crash too within minutes to maybe half an hour.
Title: Re: Run-time error 9
Post by: Botsareus on September 17, 2014, 04:58:27 PM
At some point I am going to start running IM directly from vb. I just have two zerobot experiments going on right now. Once I get a solid enough hit from at least one, I'll switch that over to survival evo and run IM from vb on a different thread, hacks and all.