Code center > Suggestions

Call to Programmers

<< < (9/17) > >>

Numsgil:
Haha! Sucker.

Solidus117:
Hi. Long time reader, first time poster

I can help out with programming if you like. I know my asm/c/c++ and can read VB. I'm brushing up on my C sharp now

I can also do algorithm analysis in the meantime if you wish, while I get familiar with C#/.NET/XNA

Thanks.

Numsgil:
The C++ code is sort of dead, so it's either going to be Visual Basic or C#, depending on if you want to work on the current code or the future code (Darwinbots 3).  Eric's maintaining the Visual Basic code, so he could probably help get you started there if you want.

With C# and Darwinbots 3, I'd really like to get someone other than me working on the GUI and graphics.  It's an important step so I can start working on the physics, but it's a lot of work.  I'll probably type up a post in the Darwinbots3 subforum explaining the different modules that need to exist.

Or if you're really ambitious you could help me work on the physics engine.  The physics and mathematics involved is pretty intense, though, compared with most other things.

Solidus117:

--- Quote from: Numsgil ---The C++ code is sort of dead, so it's either going to be Visual Basic or C#, depending on if you want to work on the current code or the future code (Darwinbots 3).  Eric's maintaining the Visual Basic code, so he could probably help get you started there if you want.

With C# and Darwinbots 3, I'd really like to get someone other than me working on the GUI and graphics.  It's an important step so I can start working on the physics, but it's a lot of work.  I'll probably type up a post in the Darwinbots3 subforum explaining the different modules that need to exist.

Or if you're really ambitious you could help me work on the physics engine.  The physics and mathematics involved is pretty intense, though, compared with most other things.
--- End quote ---

I'd rather help you out with the DB-3 work. I can also help you out with the physics if you wish, I'm almost finished my EE degree, so I'm pretty comfortable using vectors and transformations and all that jazz.

As for the GUI and graphics, I'm starting to dive into the Tao bindings and XNA. So I can eventually help with that.

Numsgil:
Oh then you rock!  I was thinking of using Tao for the graphics (played around a little with it already), or maybe XNA if they've built a version that runs on non-express studio versions.

I'll write up a post in the Darwinbots3 subforum explaining how to get the code I have and set up dependancies, the architecture I'm persuing, etc.

Have you any experience with unit testing or software system architecture?

Navigation

[0] Message Index

[#] Next page

[*] Previous page