Bots and Simulations > DNA - General
Out of interest...
Numsgil:
2.21 is the current one.
Ulciscor:
Ta very much!
Ulciscor:
OK there are some new commands I do not know and they are not in the help file (I spose those are the new commands Num made just after PY did the help file lol). Would you mind explaining them briefly and giving an example? I can guess some of them but I'd rather be sure.
.shflav, in fact all the ones starting with .sh
.velscalar, I can guess but I'd rather have a good definition lol
.bodgain & .bodlos, again I can guess but need a good answer
.thisgene ???
.vtimer,.vshoot
Sorry to be a nuisance lol.
Shen:
*.shflav returns the value of the last shot to hit the bot. So if its being shot by venom it will give you -3. Note, this doesnt reset each cycle.
*.velscalar gives you the magnitude of your velocity disregarding your heading. So you can be traveling backwards at 50 and *.velscalar will give 50 whereas *.vel will give -50. Incidently is *.velup the same as *.vel? Why have a duplicate?
Same as *.pain the difference between last cycles body and this cycles.
*.thisgene gives the number of the gene its used in. So using it in the first gene will return 1, second gene 2 etc..
vtimer is the time till another virus shot is ready. Vshoot fires the virus.
Numsgil:
check the readme, I put expanations of new commands in there.
*.velup and *.vel actually refer to the same memory location, I just wanted to maintain the nomenclature of the new sysvars while keeping it backwards comaptible.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version