Code center > Darwinbots Program Source Code

Perf changes in 2.43.1f

<< < (2/4) > >>

Testlund:
Yes, I think there is some improvement compared to earlier versions. Not sure exactly which of you latest drops though. Didn't I congratulate you on that awhile ago?
By the way I'm running with vision disabled in this sim, which also improves the speed a lot.

The_Duck:
I was running a sim in 2.43.1e at ~4.5 cycles/sec. Saving and switching to 2.43.1f gave an initial speed of ~7 cycles/sec, which has slowed over a period of ~10 minutes to 3.3 cycles/sec. Saving that, closing DB, and opening again in 2.43.1f gave an initial speed of 5.8 cycles/sec which has slowed to 3.4 cycles/sec. Saving and switching back to 2.43.1e gives a consistent 4.8 cycles/sec. So while there is an initial speed boost for -f, it quickly becomes slower than -e.

Are you expecting -f to be faster or slower than -e?

EricL:

--- Quote from: The_Duck ---Are you expecting -f to be faster or slower than -e?
--- End quote ---
It should be considerably faster for larger fields and somewhat faster for smaller fields.  Under no conditions should it be slower.  Would your mind posting your sim?

EricL:

--- Quote from: Testlund ---By the way I'm running with vision disabled in this sim, which also improves the speed a lot.
--- End quote ---
You won't notice the perf improvement if your running blind bots.  It bascially sped up vision a ton.

The_Duck:

--- Quote from: EricL ---It should be considerably faster for larger fields and somewhat faster for smaller fields.  Under no conditions should it be slower.  Would your mind posting your sim?
--- End quote ---

Here's the sim. I just tried switching from -e to -f again; after maybe 10 minutes -f was running half as fast as -e.

Navigation

[0] Message Index

[#] Next page

[*] Previous page