Code center > Darwinbots Program Source Code
C++ Source Snapshot
Testlund:
I know what ascii means, it's just that I don't know what to do with it. If you're just asking me to load the file, then that's ok. I see all the bots appear in the list, but when I click start nothing happens. Earlier I got a few bots/veggies in the corners as I mensioned above, but now I don't even get that. Just pointing it out so you can look into it.
Numsgil:
Open "lastexit.set" and check each bot where it says
0 0 1 ;PosLowRight z y x
0 1 0 ;PosTopLeft z y x
If there are other numbers, such as
0 0 0 ;PosLowRight z y x
0 0 0 ;PosTopLeft z y x
try changing it to the above. That should get bots out of the corners.
I'll try dling the snapshot and running it on another machine so I can see if I can get the same problems as you.
I think I figured it out. Open lastexit.set and change:
C:\DarwinC\Darinwbots2.5\Robots
to whatever the directory is you installed the snapshot. Alternatively you can just replace it with .\Robots
Testlund:
In that case the reason why they appear in the corners must be another one, because the coordinates for both Alga Minimalis and Animal Minimalis are these:
0 0 1 ;PosLowRight z y x
0 1 0 ;PosTopLeft z y x
No coordinates for Enitor Comesum though, just the above species.
Numsgil:
Did you try this:
Each species' path looks like C:\DarwinC\Darinwbots2.5\Robots, you need to change it to whatever the directory is you installed the snapshot. Or you can just replace it with .\Robots
Testlund:
Ok, I figured it out. It looks like the settings file that is loaded is chosen automatically; I can't chose my own settings file. The way to get it to run was to edit the 'savesett.set' file and change the paths to .\robot as you said. It runs, though it looks kind of lame as you said. Hehe. Also there is one bot that displays its black vision radius wether I like it or not. Can't unselect that. It also runs too fast, over 100 cycles/sec.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version